DimkaNewtown
Freshman
I had an solution that was built using the VS.NET 2002 on version 1.0 of the .NET framework.
I have VS.NET 2003 Enterprise Architect installed on my laptop and when I opened that solution I was asked if I wanted to convert it to the new format. So I did.
Now here's the problem. Some of the forms are deformed when I launch them. yet when I open them in the designer they look fine. Also some forms look normal on my laptop but when the application is run at the test machine (clean install) the forms are deformed again.
What I mean by deformed:
I have controls that stretch based on the size of form, now they stretch in both cases except on the test machine they either stretch too much or not enough.
Does this make sense? Has anyone encountered similar problem? I also have .NET Service Pack 2 installed on both.
I have VS.NET 2003 Enterprise Architect installed on my laptop and when I opened that solution I was asked if I wanted to convert it to the new format. So I did.
Now here's the problem. Some of the forms are deformed when I launch them. yet when I open them in the designer they look fine. Also some forms look normal on my laptop but when the application is run at the test machine (clean install) the forms are deformed again.
What I mean by deformed:
I have controls that stretch based on the size of form, now they stretch in both cases except on the test machine they either stretch too much or not enough.
Does this make sense? Has anyone encountered similar problem? I also have .NET Service Pack 2 installed on both.